Skip to Content
Skip to content
01 889 9000
Collect from Dublin 10

FIND YOUR CORE BIT

The thread is the whole game here: nearly every rig we sell is 1-1/4 inch UNC, and a bit on the wrong thread is a bit you cannot use. Start with what you are drilling with and the 33 bits, adapters and extensions narrow to the ones that will actually go on.

1 What does it screw onto? Read it off the machine spindle; adapters below bridge the rest
1-1/4 inch UNC Nearly every core rig in the range 1/2 inch GAS or BSP Handheld rigs; adapts to UNC SDS-plus Rotary hammer, not a core rig M14 Angle grinder M16 Paddle mixer thread Drill chuck Round shank, an ordinary drill
2 Bit, adapter or extension? A bit cuts, an adapter marries threads, an extension reaches deeper
Core bit Core bit The bit that cuts the hole Thread adapter Thread adapter Marries a bit to a different spindle Extension Extension Drills deeper than the bit is long Cutter or extra Cutter or extra Cone cutters, pullers, drift keys
3 How big a hole? Bits only - adapters and extensions carry no bore size
Up to 32 mm Fixings, starter bars, resin anchors 35 to 82 mm Sockets, conduit, small services 92 to 152 mm Soil pipe, vents, ducting 162 mm and up Large cores, manholes, kerb
Need the machine as well as the bit? Core drilling machines and stands ->
1 ITEM FITS matched from your choices Reset choices
Sort Featured Price low to high Price high to low Name A to Z
to
Browse this category instead ->
[17808035041] Distar DDR-B Granite Active Diamond Drill Bit ∅6-46mm (∅ 6mm)
Distar

Distar DDR-B Granite Active Diamond Drill Bit ∅6-46mm (∅ 6mm)

Diamond core bit DISTAR DDR-B GRANITE ACTIVE is a great helper to create holes of different diameters in ceramic surfaces. Most effectively shows itself in work with soft and hard ceramic tiles, as well as marble and ceramic granite. When drilling, it creates a clean edge, without damaging the general appearance of the material.
The drill bit is available in various diameters, from 6 to 46 millimeters.
The drill bit is equipped with a special shank, under the clamping chuck, which allows you to use the tool on the handheld drills. The mandatory condition for the operation is the power of the drill from 600W, the presence of a speed controller from 800 to 2000 rpm and the absence of hammer mode.
Due to the durable diamond layer, it allows to achieve maximum working speed and lifetime. Requires water cooling during drilling.
EUR 21.00EUR 25.83ex VATinc VAT